Inventor 2013 New Feature – Move EOP

This is one of my favorite new features in Inventor 2013. You can now right click on a part feature in the browser and move the end-of-part to just below the feature. No more cumbersome dragging the EOP from the bottom up.


Here’s another great list of new features from Paul Munford (@CadSetterOut) at

An Introduction to Autodesk Inventor 2013

VN:F [1.9.22_1171]
Rating: 0.0/5 (0 votes cast)

Permanent link to this article:

Leave a Reply

Your email address will not be published.

* Copy This Password *

* Type Or Paste Password Here *