Thomas Rambach

Author's posts

Assembly constraint options

Two of the most under used and misunderstood application options are related to assembly constraints. How many times have you inherited someone else’s assembly file and spent hours trying to unravel their constraint scheme? Enter the options, ‘constraint redundancy analysis’ and ‘constraint failure analysis’. Constraint redundancy analysis will analyze for duplicate constraints applied within your …

Continue reading

Permanent link to this article: http://cadtoolbox.com/2008/10/01/assembly-constraint-options/

Inventor on 2 computers and 3 screens?

If you have ever done a lot intense rendering within Inventor studio on large assemblies, you know how long the rendering process can take to create a lengthy animation. Even by breaking the animation into short segments and pasting them together later still can take hours for a few seconds of animation. One solution to …

Continue reading

Permanent link to this article: http://cadtoolbox.com/2008/08/08/inventor-on-2-computers-and-3-screens/

AUGI Cape Fear Chapter

Our AUGI Cape Fear chapter is featured in the Sept. 2007 AUGI Hot News publication. You can read the article here: http://www.augi.com/publications/hotnews.asp?page=1621. If you are in or around the Wilmington, NC area, our chapters meeting annoucements are posted on the chapters website here: http://chapters.augi.com/amug/capefear/

Permanent link to this article: http://cadtoolbox.com/2008/08/01/second-post/